Buxus sempervirens

From Treepedia
Jump to: navigation, search


Buxus sempervirens

Common Names

Common Box, Boxwood

Family

Buxaceae


Description

Popular ornamental, flowering evergreen shrub or small tree, very slow growing, greenish yellow flowers, scented foliage, very hard wood, poisonous.

foliage
flowers
bark
fruit


Foliage evergreen
Group broadleaf
Toxic Parts? yes
Height 6 - 8m
Crown Diameter 8m
Crown Shape pyramidal
Shade Tree? no
Autumn Colour? no
Age 50-150 years
Time to Maturity 45 - 50 years
Flower Colour light green
Fruit Colour brown
Bee Friendly? -




Native Areas

Western and southern Europe, northwest Africa, and southwest Asia, from southern England south to northern Morocco, and east through the northern Mediterranean region to Turkey [1].

Preferred growing conditions

Soil pH Range 5.5 - 8.5 (slightly acidic - neutral - slightly alkaline )
Soil Types sand, silt, clay, loam, chalk
Drainage well drained
Soil Fertility
Sunshine part sun
Soil Moisture normal to moist
Tolerates Exposure yes
Growth Rate - slow

Hardiness

RHS USDA EGF
H 5A H1

HardinessZones.jpg


How to plant

Water container-grown and rootballed trees well and allow to drain an hour before planting. While it drains dig out an area for the tree that is about 2 to 3 times the diameter of the container or rootball and the same depth as the container or rootball. If the soil is compacted loosen with a fork (this includes the sides of the hole). But beware of having soil that is too loose on the bottom as this will cause the tree to be lower than desired upon watering.

  • If container-grown, put the tree on its side and remove the container. Place in the hole and loosen the roots around the edges without breaking up the root ball too much. Check the depth by place a cane or stick across the diameter - only the root collar should be below and not the main stem.
  • If planting a balled and burlapped tree, remove ties or nails from the burlap at the top of the ball and using a knife if necessary, pull the top of the burlap back, so it does not stick out of the hole when the soil is replaced. Synthetic burlap should be completely removed as it will not decompose. Note burlap sticking out of the hole can wick water away from the tree.
  • For bareroot trees, feel the moisture of the roots by hand - if dry, dunk them in an bucket of water for 10-15 seconds and replace the packaging (if you are not going to plant at that time). Do not plant too deeply - only plant up to the root collar. i.e. the stem should not be covered in soil. Ensure roots are planted firmly and have good contact with the soil.

Fill in the hole with soil and compost, but do not add less than half of the original soil.

Using the soil, create a water ring around the outer edge of the hole. Not only does this conserve water, but it will also direct moisture to the perimeter roots, encouraging outer growth. Once the tree is established, the water ring may be levelled. Studies show that mulched trees grow faster than those unmulched, so add a 3 inch layer of pinestraw, compost, or pulverized bark over backfilled area.

Only prune lower damaged branches if necessary. Water newly planted trees regularly in their first year. Staking is also important in new trees and in exposed areas - a 1 m stake at 45 degrees crossing the stem at a height of 15 cm can provide good support. Be careful of the binding of the stake to ensure the tree is not strangled. Binding should be checked in the second year, as the stem will thicken.

When to plant

Early to mid-Autumn, for cold, wet sites wait until early to mid-Spring. Container-grown trees can generally be planted all year round except when it is very hot and dry or the ground is frozen.



Tree care

Hedging Potential yes
Balcony/Roof Terrace yes
Indoors no

Potential Pests and Diseases

Pests box sucker, box red spider mite, mussel scale
Diseases box blight



Ecology

The species typically grows on soils derived from chalk, limestone, usually as an understorey in forests of larger trees, most commonly associated with Fagus sylvatica forests, but also sometimes in open dry montane scrub, particularly in the Mediterranean region [1].


History and Human Connection

It has been grown for centuries in gardens for screening, hedging and topiary [2].

Uses

  • Slow growth of box renders the wood ("boxwood") very hard (possibly the hardest in Europe) and heavy, and free of grain produced by growth rings, making it ideal for cabinet-making, the crafting of clarinets, engraving, marquetry, woodturning, tool handles, mallet heads and as a substitute for ivory. The noted English engraver Thomas Bewick pioneered the use of boxwood blocks for engraving [1].
  • The leaves were formerly used in place of quinine, and as a fever reducer [1]




References

  1. 1.0 1.1 1.2 1.3 Wikipedia
  2. Trees of Britain and Europe. Tony Russell (2005)